Description
Cunningham Penile Incontinence Clamp, Regular
Cunningham Penile Incontinence Clamp, Regular 2″. Used to control stress incontinence or dribbling of urine. Constructed of soft sponge rubber and can be adjusted to fit comfortably. Single-use, non-sterile
Cunningham Penile Incontinence Clamp, Regular 2″. Used to control stress Incontinence or dribbling of urine. Constructed of soft sponge rubber and can be adjusted to fit comfortably. Single-use, non-sterile.
Product Features & Benefits
- Reusable and washable.
- Adjustable fitting.
- Effective control of stress incontinence, enuresis or bed wetting.
- Suitable for use with males of all ages.
Product Specifications
- Product Numbers: 57004053
- Size Options: Regular
- Sizes:1 – (1-1/2 inch), Size 2 – (2 inch) or Size 3 – (3 inch).
- Materials: Steel, foam and latex.
- Application: Control stress incontinence.
- Non-sterile.
- Replace every 3 months or when there are signs of deterioration, cracking, discoloration or separation of foam.
- Manufacturer: Bard Medical.
- HCPCS Code: A4356.
- UNSPSC Code: 42291802.
Product Sizing is by penis shaft circumference, not length. Three sizes are available–large, regular or juvenile. Most men use the size 2. Below is a guide to help you to select the best clamp size to meet your needs.
- Step 1: measure the circumference of your penis with a tape measure.
- Step 2: select the size that best meets your circumference measurement.
- If your circumference measurement is 3 inches or more, select the large clamp.
- If your circumference measurement is around 2 inches, select the regular clamp.
- If your circumference measurement is around 1-1/2 inches, select the juvenile clamp.
How to Properly Apply
- Step 1: Place the clamp about halfway down the shaft of your penis between the two foam pads.
- Step 2: Tighten the clamp to compress your urethra. Use the ratchet catch to adjust the pressure. This is what stops urine flow. The large and regular clamps each have 5 settings that adjust the pressure on your urethra. To release the catch, press inward on both of the spring wire loops. The juvenile clamp is not adjustable.
- Step 3: Loosen your clamp every 1 to 2 hours to allow urine to flow. Going beyond 2 hours places you at higher risk of contracting a urinary tract infection. Reposition the clamp slightly up or down the shaft or you penis so that it is not in the same place as before.
- Do not use at night while you are sleeping.
- Step 4: Ensure that the clamp is not set too tightly, cutting off blood circulation or causing skin irritation.
Cleaning Tips and Tricks
- Wash in a sink with mild soapy water.
- Rinse thoroughly with clean water.
- Gently squeeze the foam to get rid of excess water.
- Air dry at room temperature away from excess heat or direct sunlight.
- Do not use bleach, detergent, or hot water on your clamp.
- Do not put in the washer or dryer
- Do not use a blow dryer on the clamp.
